Some Installation and Start up issues

Discuss installation issues/solutions for Engarde

Moderators: scrumpy, Dave, leihog

Some Installation and Start up issues

Postby RKB on Mon Aug 16, 2010 9:11 am

Hopefully someone will have a bit of time to assist me here;

Problem 1 : After installation and reboot the system comes upto a screen to either select Standard or Secure, at the bottom of the screen is boot: and my cursor is flashing and I can not select or type anything.

Problem 2: Is which are the correct IP address to use.

My system:
Sunfire V40z server connected to a network through a switch and the internet through a modem gateway.

To confirm the hardware works (it's New) I installed Win 7 and the system installed and connected to the network and Internet, no problem.

I have removed Win 7 and reinstalled EnGarde.
My ISP has given me a static IP of 205.xxx.xxx.xxx
My ISP has DNS server IP's of 657.XXX.xxx.xxx and 675.xxx.xxx.xxx

My Modem Gateway has an IP of 10.1.1.1
The other computers on the network have the IP's fixed

When I installed Win 7 I let it install using DHCP and it allocated
10.1.1.10 to eth0 255.255.255.0
10.1.1.11 to eth1 255.255.255.0

Gateway 10.1.1.1
DHCP: Server 10.1.1.1
DNS Server 10.1.1.1

When I install these numbers into EnGarde there is no Network or Internet Connection.

Any help appreciated

Cheers

Ron
RKB
 
Posts: 12
Joined: Thu Jan 15, 2009 10:15 pm
Location: Sippy Downs. Queensland. Australia

Re: Some Installation and Start up issues

Postby Dave on Tue Aug 31, 2010 1:31 pm

RKB wrote:Hopefully someone will have a bit of time to assist me here;

Problem 1 : After installation and reboot the system comes upto a screen to either select Standard or Secure, at the bottom of the screen is boot: and my cursor is flashing and I can not select or type anything.

What type of keyboard do you have? It should timeout and boot on its own. Do you have control of the keyboard once it boots?

Problem 2: Is which are the correct IP address to use.
When I install these numbers into EnGarde there is no Network or Internet Connection.

What type of ethernet controller do you have? Can you look through the dmesg and lsmod output for an indication of which ethernet controller you have so we can troubleshoot it.

Regards,
Dave
Dave
Site Admin
 
Posts: 107
Joined: Tue Jun 13, 2006 6:06 pm

Re: Some Installation and Start up issues

Postby RKB on Mon Oct 11, 2010 4:15 am

Tried all keyboards, old, new, USB No difference

Broadcom NetXtreme V7.6.6

Cheers

Ron
RKB
 
Posts: 12
Joined: Thu Jan 15, 2009 10:15 pm
Location: Sippy Downs. Queensland. Australia


Return to Installation

Who is online

Users browsing this forum: No registered users and 2 guests

cron