CRON and Symbolicaly linked Folders Problem

Discuss general troubleshooting concerns.

Moderators: scrumpy, Dave, leihog

CRON and Symbolicaly linked Folders Problem

Postby iandavies999 on Tue Sep 21, 2010 10:10 am

I have 2 issues which cause me problems when running in enforcing mode, if I run in permissive mode they work fine.

1) I have a Cron job created which runs fine when the system is running in permissive mode, I can even see the job listed. If I run the system in enforcing mode the job doesn't run and the cron job doesn't show in the list.

2) I have 2 folders which are symbolically linked to back to FTPSECURE directory. Again when running in permissive mode, clients can see and connect to them but when running in enforcing mode neither of the folders show.

I am trying to upgrade from Verision 1 of Engarde to Verision 3, in Version 1 none of the above problems exists when running in enforcing mode.

Can anybody please offer me some advice as I need to correct these problems to do a succesfull rollout and upgrade.

Thanks in advance

Posts: 4
Joined: Thu Sep 16, 2010 11:12 am

Return to General Troubleshooting

Who is online

Users browsing this forum: No registered users and 3 guests